MASTER CLASS RIM WITH DANDELIONS AND DAISIES FROM FOAMIRAN

Send

Such a hair ornament will be a great addition to everyday clothes.

To make such a composition, we take the materials:
- plastic suede of white and green and yellow.
- scissors.
- the rim is iron.
- satin ribbon 1 cm wide.
- lighter.
- tweezers.
- a little wide kapron ribbon of two colors.
- thin wire.
- foil.
- glue gun.
- four yellow semi beads for daisies.
- a few green leaves of fabric.
- a needle with a thread.
- stamens for flowers.
- a little thin green fabric.
- ladybug for decoration.
We will work without templates and tools. Let's start by preparing the basis for the whole composition. We take an iron rim and a thin green ribbon 1 cm wide.

And gently wrap the entire rim with this tape, gluing in several places with a gun. The foundation is ready. The fabric will allow a strong connection of all small parts.

Now we will make a bow. We take a wide ribbon of either one color or two shades. Cut 4 strips of 11 cm.

Fold each segment in half. We should leave the triangle. To do this, press the folded tape with tweezers from corner to corner. The narrow side of the triangle should be at the fold of the tape. We cut it close to the tweezers and we burn this edge with a lighter, the tape is soldered and an even seam is obtained.

And interesting workpieces are obtained.

Now with the help of a needle with a thread, we collect the wide side of the parts with small stitches and pull them together. It turns out four volumetric petals.

It remains only to connect them together and fix the stamens for flowers in the middle of a large bow.

Now let's start making dandelions. From yellow suede we cut 3 strips of 40 cm long and 1.5 cm wide. Then they need to be cut with scissors like a fringe. And for the base of the flower, you need to fix a little foil on the wire of 8 cm, and form a droplet of 1 cm.

Then you should glue this strip by screwing it onto the base. We make sure that the bottom cut is even in one line.

To make a sepal of flowers, cut a strip of 1.5 cm wide from green suede. And the length should be measured in colors, perhaps a different length will be obtained. But with green fringe you still need to make a twist. Just fold the strip several times, and then slightly twist the thin, free edges with your fingers. And then fasten around the edge with a gun.

And yet the bottom of the dandelion should be closed with a green circle.

And then, using the heat from the lighter, you first need to open the sepals, and then the flower itself. Gently warm the dandelion petals and straighten with your fingers, open.

But there are daisies on our rim. We will make 4 flowers. Each daisy has two rows of petals. Therefore, we cut out 8 circles from a white foamiran with a diameter of 5 cm. Then we divide each circle into 12 petals. It is easier to first cut into 6 lobes, and then still each in half. The center of the flower circle of 1 cm should not be cut.

Next, in each petal, cut off the upper corners, give them the right shape.

And to give a new shape, we will again use a lighter. Separately, each petal is heated from below, and with our fingers we fold in half in length. We process all flower circles.

It remains only to collect flowers. For one we take a wire 8 cm long. On the one hand we do rounding in several turns. We take a yellow bead to the floor, cut out a small green circle and a strip of green fabric.

The assembly itself is simple. We pierce two petal circles with a wire and glue them in a checkerboard pattern. In the middle of the flower, on a twist of wire we fix the yellow blank. The sepals will be a small circle and we glue the wire itself with a strip of fabric.

All the flowers are ready and now we proceed to the assembly on the rim itself. We have 3 dandelions, 4 daisies, a ribbon decoration, a ladybug to complement, several fabric leaves.

Let's start glue the ribbon decoration with the gun. We are located below the middle. We divide the ponytails from the stamens and place them on the rim in different directions, firmly glue. And we fasten the tapes in two places.

Further down, where there is a shorter distance to the edge, we fix the camomile. We place the stem along the rim and cover it with a green leaf.

Now on the other side of the ribbons we attach a dandelion. We wrap the bezel from it with wire. And right next to it, sinking down, glue three daisies. We fix the mounting points with the rim with tape and a sheet.

After a bouquet of daisies, we fasten two more dandelions, complementing them with leaves.

Now you should pay attention to the wrong side of the rim. And where gluing points are visible, you need to fix the green leaves. Everything should be neat.

On the edges of the flower row we glue on a leaf, it is possible with stamens. And now there is only one dandelion left to glue a ladybug. The entire rim is assembled, the decoration is ready.