Are you tired of wires constantly getting under your feet? Then this homemade product is for you! In this review, we will tell you how to make a coil for a wire from improvised materials.
To make it, you will need plates for flower pots, a bicycle sleeve, polypropylene tubes, tees and plugs. Special skills in the manufacture of this homemade product is not required.
Initially, the plates will need to drill holes equal to the diameter of the sleeve. We insert the sleeve and mark the holes for the connection, drill them. We fix the sleeve with plates on a threaded or riveted connection. We get a kind of wire drum.
The main stages of work
Next, proceed to soldering the tubes. We cut out all tubes of arbitrary diameter to a single size. We solder, according to the drawing, the entire structure. We make a hole in the central tube. If desired, you can paint this part.
We fix the previously made drum on the stand with the nut and washer. Next, we need to drill a hole in the outer plate for the wire we need. From a piece of a polypropylene pipe of a larger diameter, cut a ring a little wider than the cross section of the wire.
Glue a piece of plastic with slots at the edges (to fix the wire). We wind the wire we need and our homemade product is ready. Detailed coil manufacturing can be seen in the video below.
